RC Rover Platform
Hardware- 5 Devlogs
- 7 Total hours
A remote controlled RC rover powered by Arduino.
Finished the cad design for the rover!
Finally finished the wiring diagram. Since I’m new to schematics and Kicad, I made some errors along the way that made the whole thing take longer than expected. However, it was all worth it. I plan to start the Arduino code next. Now that I’ve submitted for funding, I can hopefully show up with some live building devlogs soon :)
Worked on wiring diagram. Still in progress!
Worked on an enclosure for the rover’s remote control. As a beginner at CAD, this was great practice. Can’t wait to see how this will evolve as I keep building!
Designed a first version for my rover. I decided that 4WD is worth the cost because I can control each wheel. There were so many sensor options this project could have taken, but for now I chose an ultrasonic and an IMU. For the physical remote controller I’m going to make a simple one with one joystick. Excited to see where this goes!
