8/27/2026 - 17th Update!

ok, 10:39 PM, lets speed through this!

ok, quite a bit of rotating stuff on jlcpcb’s side, but here it is!

it should mostly be good? only thing im not sure of is the crystal but yeah!

hopefully when i reload the page it saves…

no it doesnt. well, thats annoying.

well, 11:21 PM, made an application for the sd card thing to actually get a model, so yeah, not much i can do today, unfortunately? just kididng, cad could use some work, brb

ok, 11:47 PM, im back!

shrunk the middle section from 1.4cm to 0.75cm! nvm its back at 0.95cm, anyways, total height decreased from 2.1cm to 1.5cm! ok, 11:54 PM, brb!

back at 12:44 AM, i guess its a good time to assemble a bom? (for the other parts)

well, 1:07 AM, that wasnt really much… yeah, gotta wait till the 3d model for the micro sd card slot appears or i just gotta replace it, idk, but yeah, i guess ill check tomorrow evening, if its not there, i guess ill just replace it? but yeah, 1:21 AM now (yes i got distracted), so yeah, good night!