You are browsing as a guest. Sign up (or log in) to start making projects!

3h 26m 36s logged

Final Run

Printing

As I mentioned before, I scaled everything 1.5x and printed them with the PLA+ I recently bought. I had a slight issue with my printing plate that made a corner not stick to itself, but I minimized this error using some special glue I bought for printing plate, and surprisingly, not using that corner. I got the main piece done, and moved on to printing the top piece, which turned out to be hard considering I had low filament left in my printer, but I got the shape printed with no functionality loss (everything fit inside).

Combining

I placed the necessary parts inside first, especially buttons, switches, and USB-C charging ports, and then I rewired them. After putting them in position, I used hot silicon to pin parts into place, including the touch sensors, LCDs, and LEDs.
I also used the magnets I used in my smaller print on this, but I forgot to check polarity (again), so I had to rewire the magnets again.
Finally, I closed the big case with screws, and the small with hot silicon applied in between the parts (screws were too big for that gap between them).

Result

I have a working timer prototype, which can be reduced both in size and price by creating a PCB, or regular software updates can be made for the ESPs so that it has more features than the one I provide.

0
18

Comments 0

No comments yet. Be the first!