Today was an ultimate lock in day. It says 3 hours, but I totally forgot about lapse for two hours before so in total I worked around 5 hours. My goals of course was to completely finish and submit project. I did not do that but I am definitely pretty close. Here is everything I did today. I switched back to the BMI270, I asked for help on my PCB from reddit, hack club slack, and on of my dad’s colleagues (meeting is tommorow), I moved to CAD where I made my walls thinner, fixed the holes for the PCB, added both PCB, the main frame, the screw, the dowels, the sensor PCB, and the nut carriage in an assembly view, I created a small carriage for the end of the screw so that the screw actually moves the PCB back and forth, then I moved to firmware and wrote a complete firmware that checks all the components (FSR, IMU, OLED, SD card) and has a loop which does the simple function for the board. Tommorow I just need to collect this all into a GitHub, do some last minute PCB/BOM checks and I can submit!