Finally :D I completed the PCB and the case! It looks really cool, but I definitely had to spend a lot of time on it. The PCB was a bit challenging, but the case was pretty easy to make.For the firmware, I initially planned to use QMK, but after spending a whole hour trying to set it up without success, I decided to delete it and switch to KMK. Later, someone in Slack told me that I could work on the firmware once the hardware arrives, so now I’m basically at the final steps of completing the project!For the case, I added four little supports on the bottom to help reduce damage to the case. And honestly, the silkscreen on the PCB is probably my favorite part! :D