I have no idea what i’m doing but i was able to get qmk setup with a lot of patience and waiting for files to load, and now i have a rudimentary firmware to push

holy freaking sheet basically went through the pricing for the macroboard and found out that i sized my pcb wrong so i was getting a much higher quote at jlcpcb than what i was actually supposed to get, so i had to redo the edge cuts for the pcb

i was also worried about the clear part of my mounting
board so i found out that jlcpcb also 3d prints resin parts so hopefully i can use their services because it was pretty cheap from what i saw

also about resizing my pcb, i had to completely redo the
case. thankfully, i’ve learned from my past experiences and actually know what i want. basically i was walking blind through my case last time which helped me know a lot about what i needed for my case this time, and decided to simplify it a ton more because the case was pretty complicated last time. also i know how to simplify the pcb so that it actually runs on my onshape this time :)