2 updates to the project, I 3d printed the MK1 top piece with varying success and modelled the MK1 base panel. after ages of waiting for the 3d printer I rent to be free I printed it, it fits the case and the components well (although the screen hole was a lot bigger than it needed to be) however I encountered 2 major errors 1. the dowels I used to connect the two half’s were to big and made gaps in the model, and 2. I may or may not have forgotten to turn supports on witched caused the model to sag a bit but it turned out ok in the end. Next I plan on printing the base panel and re-modelling the top panel.