we finally got our intake and shooter to work! i mostly helped by tensioning the neoprene rubber strips and using rubber glue to secure it. earlier, i was trying to make a 3d print to make it easier to cut the rubber strip so that it can be cut at an angle, allowing me to overlap the rubber without making the conveyor too thick. however, that didn’t end up working because the rubber was difficult to cut, so we just decided to glue one on top of the other. one issue we ran into was that on the overlapped portion, it would jam into the pulley for the shooter. this was eventually fixed by cutting the part of the rubber conveyor that was too thick and would hit the pulley! with the extra scraps of rubber that i messed up on, i made a little dude with scissors