Gantry design is hard.

Light blue part on the left side of the image is the new mount. Fun fact; as part of making this mount I learned that my master sketch was slightly off and in fixing this I made literally every existing part change. Parametric is magical and made it not too annoying to fix, but still. An annoying and confusing half hour. The bearings actually hold the belt in the right spot now, though, so that’s good.

Now is when the second photo comes in to play. This is the theoretical absolute maximum travel possible…108mm

So now I get to chop the front 12mm off of the mount. Not sure if I should just…remake it from scratch, or what. Might just cut it and one of the part studios will be cooked.