My awesome macropad!
Hardware
By
@_jacy
- 7 Devlogs
- 7 Total hours
A 3x3 macropad
@_jacy
on
My awesome macropad!
58m 4s logged
Im working on a hinge mechanism that would allow me to adjust the angle of the macropad on a monitor riser. It’s basically just going to clip on then im going to use a 3d printed bolt that tightens and holds it together.
@_jacy
on
My awesome macropad!
1h 7m 21s logged
Working on the code right now QMK is being really annoying its like failing constantly and says some random stuff its probably just I did something wrong in the code its my first time using Kicad
@_jacy
on
My awesome macropad!
33m logged
Finished designing the first case design im not completely sure about the dimensions so im going to modify it after I get it
@_jacy
on
My awesome macropad!
1h 18m 1s logged
Just finished running all of the traces on the circuit board and organising everything. Now onto the case for the Macropad
@_jacy
on
My awesome macropad!
35m logged
I finished moving all of the electronics onto the PCB editor. Next up, I need to wire everything and make sure everything is ok.
@_jacy
on
My awesome macropad!
1h 53m 12s logged
DEV POST #2: Finished first sketch of my macropad. It will include 9 keys, 2 rotary encoders, 9 led’s and a seeeduino Xiao. Next dev post will be hopefully finished PCB
@_jacy
on
My awesome macropad!
35m 13s logged
Just created my first PCB using the tutorial!! My plan is to now design my own custom PCB without the tutorial hope all goes well fingers crossed.
