x3 - Today I mainly worked on the motor mount, such as adding fins, and struggling to add the mesh that would be in the motor mount. I also added the mount in the body and the electronics bay (it will separate between green and yellow. Originally I wanted to do a body mount just through a rod straight down the middle, but I decided to push it to one side to make it stronger, and make it easier to print. I am still working on the camera mount and I am about to start on v3. v1 was too simple and didn’t allow the camera to tilt 45 degrees down, which is the goal. v2 was over complicated and had horrible airflow that would pull the rocket to one side. After working on the camera mount I need to start working on the wiring and code for the camera!