Finished the LED PCB for the flashlight module

I couldn’t fit 40 LEDs like I said I would so there are 30 LEDs. It should still have close to 9000 lm max brightness (It will probably run only for a few seconds at max brightness before it will overheat). I’m just going to drive the LEDs little harder.
I first wanted to have connectors for power and the thermistor but I found that JLCPCB only offers 1 layer aluminum core PCBs so I was limited to a 1 layer PCB and I couldn’t use THT connectors so instead I’m going to solder the wires straight to the board.