I finished my schematic!!!

Read the journal.md for a more in depth explanation. I basically chose all of my footprints for each part (most of them either screw terminal so I could connect it to the rest of the electrical systems easily) and wired everything in KiCAD again.

This is like my third rewire and I finally got it good bc I fixed a lot for stuff involving the positioning of the resistors. I also realized a lot of my modules that I needed required a lot more wires so I added those in quickly. I also made my own Arduino Nano and ESP32 schematics from two 15x1 connector schematics so I could ensure each pin was correctly labeled.