Dev Log 11 (18/07/26)
Alr yeah took a 10 day break but back at it again, had to make changes to my PCB cause i didnt know about settings design constrains so some of my clearances were wrong…. butttt I work on the casing today and got the hardest part of the casing done, man i was stuck on this part forever…. i swear the longest part of designing smth is thinking of ideas over and over again… *screaming internally, like i spent so so so so long trying to figure out how to add in a plate to support the MX switches while using no screws and allowing room for the OLED and its driver board… Turns out i was OVERTHINKING…. and the solution was so simple, just create a hole for it and design a cool looking lid to cover it.
–––––––––– What did I learn? —————––
Dont overthink stuff.
———————What will i do next time?–––––––
Work on the case, should be done within a couple of hours, and its not going to a plain box…