Frog Pad Devlog 003: AHHHHHHH

So I had to redo the PCB. Three Times. It was easier than rearranging all the parts to reorder them, but it sure did take a lot of trial and error. I had multiple YouTube Tutorials open; I am sorry to whoever watches my Lapse clips because I made a lot of cuts trying to not count research time.

Most of today was reorganizing my parts for wiring/copper-ing and trying to align all my parts. I was going to do edge cuts today but it’s 10 PM right now and I have to be up in 8 hours. But everything’s connected!

Tomorrow is hopefully edge cuts and updating the silkscreen, then running a sanity check before I do this all over again with OnShape.

🐸🗒️!