This one isn’t going to look like much progress per amount of time compared to the others, but here we go. I assigned pcb footprints to all my components. Then, I started on the pcb, only to realize that some of those footprints are a bit large for a 20 x 50 mm board. So after a lot of attempting to make it work, I finally changed to smaller resistor and capacitor footprints. I will also likely change my button and crystal footprints later, since they are a bit too large as well, but I’ll do that when I get to that part of the board. Anyway, I’m finished with the usb power and data parts of the pcb (for now) and have to do the main core and I/O next, which will likely be a pain, (Hence why my starting sections are so cramped) but I figured I should stop here to make a log. Hoping all goes well in the next steps!