DEVLOG #45

The setup recorded 5,165 raw frames in a short test, but the run still failed because its rejection log overflowed. I expanded that bounded log and moved slow startup hashing out of the packet-processing locks.

I also installed RX1’s new memory-diagnostic firmware and checked it for about 15 minutes. The old heap dip didn’t reappear, although that doesn’t prove its cause is fixed.

Wi-Fi is now the main headache. TX1’s access point restarted internally, and the receivers didn’t reliably reconnect. Restarting them helped temporarily, but the problem returned. I found a firmware path where an immediately failed reconnect schedules no further attempt. The corrected candidate is built and tested offline, with extra UART diagnostics to capture what happens during a real failure. The actual outage cause is still unproven.

Next: check the reconnect candidate on hardware, capture the failure, then retry the short recording and full baseline/peer comparison.