got the v1 collector off the printer and took a looksee, tolerance was… almost there. I’ll probably do a little more next time for the clamp. The main issue was that the lip of the bulb holder and the starting curve of the collector were simply too close. An extended region of about another 10 mm in height should fix the problem plus I’ll change the sides to go up straight… ish? not the curved version. Plus, needs more clamps and or a better method of attachment after grtting it around. wait. So. I may be silly. I could print it all in one go… because i can slide it in…. oh… my… getting it to stay i could use pins somehow. Unsure. The sides will also need to be much thicker in order to be able to mount the lenses on, but this was a good test of concept! I’m pretty happy with it all things considered about 2 hours for a print and a couple of mishaps but came out ok. I’m not super deep into printing settings yet so if you have recommendations… lmk.