fighting with CAD, I don’t usually use OnShape since at my school we used inventor, but that requires a license and so far onshape has not been too bad. I may download fusion later but just haven’t gotten to all that. I got a clamp set up designed for around the bulb housing and I have an idea in mind but modeling it is a little harder then expected. As per usual, with CAD. I also don’t often use assemblies so I might have to look up a couple of videos on that as well. I added tolerance and I’m hoping when I give it a test print it should be ok, but knowing 3D printing there might be something wrong at some point. I’m trying to design it in a way that it can be printed facing up with minimal supports. Hopefully! (these are the measurements of the insides of the lenses)