Mr. Clown is pretty much finished!

I had a little bit of trouble with finding a battery pack to power the Pico. The first one I tried was old and restarted when the servo tried to move. The second one timed out during a wait, but I changed the code to start when a makeshift button is pressed instead of waiting a set number of seconds.
In addition to adding the two wires that start the code when connected, I:

• Wrote the firmware for Mr. Clown
• Figured out the MicroPico extension for sending the code to the Raspberry Pi
• Added a cardboard box to hold the extra clown nose

I also decided what I am going to say during each section of the trick (the patter) and exactly which sleights I am going to use to make the clown nose disappear.