After shipping yesterday I had today started working on riping
TwinkleTron out of my table, and overwriting it with the latest FW.
Then I began configuring it.
I have set up the LED strip channels as one can only do 800 LED’s
reliably. It was split in the middle by 576 pixels.
After I peeked into the matrix config set up the defined matrix size and
it didn’t look right. Went to readme to spot the mistake ant it was
because I’ve wrongly converted from mm to cm. OR so I thought. It was
the whole calculation that was wrong. 🤦‍♂️
MATHS

Boink I got an notification that my ship was rejected and needs changes.
(No images in readme and no BOM)

Back to the project, and after a few blank stares into the readme and
also the CAD file I’ve managed to at least hopefully correctly calculate
the needed LEDs. SO I had to redesign the power delivery section.
Updated the repo for requested changes and shipped it back out.

PS: I also managed to get the price down :yay