Finally going to submit!! I’ve finished the PCB and the readme (for now). I made blender renders of the PCB. I used a random HDRI I found online and hit render. Also I had to change the PCB as the footprint I was using for the resistors and capacitors were too small for the ones that I actually wanted to use. In fairness to me; it’s difficult to pick the right one when all the footprint names are “R_0201_0603Metric”. It’s so confusing that even claude got it wrong. It said that the second number was metric and the first was imperial and that LCSC has there components listed in metric. That’s wrong, I’m not sure what part of it is wrong - all I know is that the number I wanted for LCSC was the first one. I also changed the footprints so they aren’t the hand-solder ones. This is after @heki told me that it may cause issues, yesterday. This will not be my final post on this design as I guarantee that there will be some issue with the design or repo that requires me to re-submit but we’ll see. I also updated the readme to a some-what final state (until I actually get the boards). It has more info if you want to check it out. The repo is a bit messy at the minute so I need to tidy that up at a later date. Now I just need to wait to get it rejected to do any more work on it. Until then, thanks for reading !!