it has been built! it is so loud!

I finished designing the ducting and finished printing out everything, immediately a couple problems: ducts bump into bltouch (this was also in the cad but i didn’t notice) and the ducts are really flimsy. The ducts themselves are fine but the front plate is too thin to keep it in place properly. They work but it’s kinda sketchy. To fix the bltouch thing I just melted the ducts with my soldering iron, already remodeled a fixed version but have yet to print.

The extruder seems to be not tuned very well. I set the manufacturer-recommended esteps, but it could be off. The cooling also seems to be sketchy? I can feel an insane amount of airflow but i don’t know if it’s going to the part yet. It aims a little low and I reprinted a bridging test I made earlier and the results seem to be worse.

I also need to do some fixes later if i want to use this long-term. I couldn’t make a new extruder cable because my crimping tool couldn’t handle jst-ph, so i’m gonna have to deal with the stock extruder cable which severely limits the amount of vertical travel I can handle.