Been a while since I worked on this, but I made a ton of progress and did a ton of off-camera research. First of all, I decided to go from a 14s2p battery pack to a 16s2p pack because I didn’t realise that the hub motor is rated for 60V, but there wasn’t enough space in the compartment to store that big of a pack, so I had to spend some time in CAD to extend the overall length by 2 inches. A few other things I did: I decided to use aluminum sheets for the base; the footpads are now 3D printed instead of wooden (I might go back to wooden, not sure yet), and I decided to use both electronic footpads and a remote control for better and safer riding. Now there is just some polishing to do in CAD, and then its just building the actual thing.