Been a while since my last devlog but I finished designing the case and a first draft of the firmware. No huge challenges with the case, I’m not super confident in my alignment on everything but I think it should work. Writing firmware was fairly difficult due to limited documentation for circuitpython, but I was able to find some sources and miiight have used a few VScode inline suggestions. While procrastinating on that firmware, I made a nice little render of the hackpad in tinkercad… yes… tinkercad, because onshape doesn’t support STL files in the ways I needed it to. Anyways once I finish uploading everything to the github repo I should be ready to submit!