I finished updating the CAD files for my Upcycler project today!

I fixed the problem of the bodies’ legs always cracking when you screw in their screws too tight. I did that by creating notches for their caps to settle in. This should also keep the legs sturdy over long-term wear.

Another problem I’ve had for a while was the bodies not lining up in the assemblies for some reason. I found the root of that problem while improving the legs. The legs were actually slightly offset on the bodies on the x-axis for some reason. I was able to fix that easily when reattaching the legs. Redoing the base to fit this change was more difficult, but a bit of brute force did the trick ;)

I’ll be printing these new parts out now. After replacing the old ones, the Upcycler V3 will be done!