@Liam-_-

i hafe no idea what i hafe to do the drc manly complains about Plate edge free space violation

i hafe no idea what i am doing this stupid drc says everytime i do something wrong

i removed 3 leds so its easyer to connect them but once again the dumb drc says nope

i think i hafe an idea how it could work now

i dont know if its right or not ill just try

i need to start over i guess i noticed my planed parts and stuff was to much to fit the size i imagined and also the drc errors confiused me

i dont even know what i did i think i connected the leds with the seeduino and then run the drc wich gave me a lot of errors and warinings wich i dont understand
if anyone has a tip what i hafe to do i would really appreciate

PCB design is more complex then expected

i did the footprint assignment tool and then worked on the pcb design i didnt knew how i want it too look and when i wasnted to draw the connection i t didnt worked out so i am still on working on the pcb

Hi i think i am finally done with my scametic after last time i had problem with lapse i made a pause. i at first wanted to check everything i did then tried to organize it better after that i connected everything what wasnt connected found out i made a hole lot of dump mistakes wich i at first didnt knew what caused them but after asking a ki i found out and solved every error

i tried to get gemini explain matrix wiring to me but didnt worked out good then i tried to follow someone elses worke so i hafe a basis so i can personalize it frome then on. guess i need a lot more of trial and error.

it is the first time i ever tried myself on something like that i basecly followd the tutorial and then wanted to personalize it like you shuld do but because i never did something like that i tried to figure out what has to connect to what i know mostly of that is probaply wrong connected or so but i dint waned to ask ai instantly