Dialpad!

Added leds. Short of ONE PIN.
Right now, added 12 rgb leds for each key. But not able to wire one data pin for them or I should sacrifice a rotary encoder. Heart breaking.
Any help is appreciated.

The Hack: using a didode to drop about 0.6v for the first led alone to make it act as a singal voltage booster for rest of the leds at 5volts.

Schematic Done!

This is a hybrid macropad design that allows me to swap between an OLED display or a joystick via jumpers. Sounds cool right?

12 switches and 2 enoders are always functional. all within just 11 GPIO’s…

Matrix wiring logic was insane to me at starting, but now I can design almost anything with the least amount of GPIO’s possible.

The problem? one of two encoder switches and joystick switch cannot be used in this design.
Got any suggestions? lmk.

Got to create a github repo.
create the pcb
design a casing
and finally my pad is ready!!!