Making My PC (3d Model)

Ship #1 Pending review

@Ben_A on Making My PC (3d Model) · about 2 hours ago

I attempted to learn Onshape while attempting to recreate my PC as a printable CAD model. I was surprised over how close it was to Solidworks in terms of editing and features that I used and was able to complete the project faster than I was expecting. The most difficult part of the process for me was getting used to the slightly different controls on Onshape and creating the organic tubes for the AIO part of the PC! I have put the STL and Step files on the Guthub Repo.

2 devlogs
1h

Try project → See source code →

Open comments for this post

@Ben_A on Making My PC (3d Model) · about 3 hours ago

44m 59s logged

Update 2:
I was finally able to finish modeling the Pc in onshape, The aio tubes took sooo long for me to figure out, but I was able to achieve the desired effect with the Sweep function in Onshape - once I finish adding colors to the PC will be done!

Open comments for this post

@Ben_A on Making My PC (3d Model) · about 4 hours ago

41m 7s logged

Update #1
I have finally understood most of the controls and features that OnShape offers, and I have gotten pretty far in my project to replicate my PC in CAD. It is very similar to SolidWorks which I am familiar with but was not expecting and it has made this project go by a lot quicker than I had originally anticipated….

I still have to add the hardest part to my model, the aio tubes, then I can work on the case and recoloring the model to look like my PC!