Macropad for onshape

Hardware

3 Devlogs
4 Total hours

A macropad for some basic onshape commands Like n for full view(definitely most important) L for sketching lines C for circles D for dimension and shift-e for extrude

Ship #1 Changes requested

@dogod on Macropad for onshape · 26 days ago

I made both a complete PCB that can be made by anyone its under the GPL if you want to use it and also made a case that should work i don’t know i didn’t make any test prints so do it at your own risk

3 devlogs
4h build

Video of Project → See source code →

Open comments for this post

@dogod on Macropad for onshape · 26 days ago

37m 32s logged

Finished the case this should be way more time but i forgot to download the Wakatime extension so I didn’t get all my time marked down this would have ended up being like an additional 3 more hours so that sucks but at least it is finished.

Open comments for this post

@dogod on Macropad for onshape · about 2 months ago

2h 28m 30s logged

Okay so i finished the PCB i was kinda slow cause i have been doing a lot this summer buts its ready now

Open comments for this post

@dogod on Macropad for onshape · 3 months ago

33m 34s logged

I basically just designed a casing for the macropad internals. I have also been deciding on what type of button I should use as honestly both look good. But I should be done with the case I just need to make a port for a type c plug then I will begin work on the PCB which I thankfully have more experience with.