multi-spec macro pad
Hardware
By
@LawlietSky
- 3 Devlogs
- 3 Total hours
a macropad with 9 programmable keys, a volume control rotary encoder and a joystick, cause why not?
@LawlietSky
on
multi-spec macro pad
23m logged
noticed that the holes for the keys were too small, went ahead and fixed that, i also made a little tray in the empty space to accomodate my most used stationary. still got space for the stickers, just gotta get creative. i also did manage to get the pcb’s model but there were no models for the joystick so its just a hole.
@LawlietSky
on
multi-spec macro pad
1h 51m 1s logged
The 3d model for my macro pad is done!, the face plate was the hardest as i had to make it myself and wasnt able to use the tool listed in the guide, i ultimateley decided against the fancy pcb as that wouldve been wayyyy too much work, so the empty space is now reserved for hackclub stickers, i cant find any other place to stick them tbh. well that was a fun part, next up is coding the firmware…
@LawlietSky
on
multi-spec macro pad
1h 6m 1s logged
I just made this PCB for my macro pad but now i see that there is far too much space up at the top left corner, i don’t have any more GPIO pins to put anything there and i don’t think i would even need anything more than this, i am thinking of just making a weirdly shaped PCB so i can make a cool case for it, by cutting off places without components, and maybe add stuff like a pen holder and stuff. I’d love for you to tell me a few suggestions on what to add!
