FINALLY finishing my 3d case for my antenna rotor controller

The whole project is pretty simplistic looking back, the case consists of 2 parts(Lid+Case), each with basic decoration such as text and images. I originally wanted to add a mesh texture above the MCU to let some sort of airflow into the case and make sure the electronics dont overheat, but after some reflection and a little bit of laziness, I let that idea go. For the PCB, nothings really changed since the last devlog, I added a LED connected to Vcc to signal that the board is receiving power when I plug it in.

My next step is to program the firmware for the board and print the case at my local library.

PS: Took me about 8h from start to finish ( Schematic+PCB+ Case) to design what you see in the pictures below and considering that those 8h include the full learning process ( for Onshape + Kicad), Im rather proud.