After roughly ~16 hours of 3D modelling, the enclosure for MagniAssist is finally done! During this session other than cleaning up the final design to make it look better, I also designed the magnetic back for MagniAssist. The magnetic back for MagniAssist will be made from 6x2mm Neodymium magnets. I designed it so that you will have to stop the print 3/4 of the way before the 3d printer puts filament over the holes in order to place the magnets in the print (meaning that it will be permanent). The magnetic back will be printed in three parts and will be connected by a string of PLA filament that’s 1.8mm in diameter.