Devlog #1 - Car Wheel: Apparently the stupid RECORDING didn’t even capture my build, because probably stardance didn’t detect it but we’ll make the best of it. I think from now on I am going to do the screen recording thing, because I just tested it and it worked way better than the lookout app. To start off with this very hard project (as a newbie who is new to 3D Modeling), i sketched a circle, and extruded it to make the small cylinder thingy, then I sketched more of those circles and remove-extruded them to put the details into the wheel itself. I think the most hardest part about this build is the fact that this part isn’t even centered to begin with (I eventually figured out how to put it back on the origin). For the details on the tire I sketched it and revolved it around to make the black circle thing, and I drew arrows for my tread choice, and put it though a circular pattern so it could be all around the tire. Then for the very last final touches I filet/chamfered the rough edges of the rim to make it look a little bit more neat. I’m pretty excited to see where this project goes and where it will advance!