DEVLOG # 3

Main tasks did:

1. Rerouting of pcb traces and schematic
2. Adding 3d models into the pcb
3. Comparing pcb 3d model with preview 3d sketch
4. Sketching out the case (ROTOM!)

Rewiring of the schematics; due to not reading online forums after I had routed. Turns out I had routed some things wrong.
The pcb tracing was not organized (used the wrong scale 😭)
Then started sketching the 3d model that resembles a rotom, this was harder then I thought ( Fusion 360 ≠ Blender).
Might do the intitail case design in fusion then do some editting in blender.

Next Devlog To do:

1. Case design
2. Make the case look like rotom