UV and Ozone Sterilization chamber
Hardware- 8 Devlogs
- 15 Total hours
UV and Ozone Sterilization Chamber for Personal and Household Use
Super cool project. Be careful though!
hi there! this is really cool but your CAD model is incomplete! i would read this page
https://codex.hackclub.com/other/returns/
can't wait to see you resubmit!
I worked on the firmware today.
Man, I’m exhausted! It took forever!
I think I’ll sleep really well tonight.
Also, the firmware ended up looking really ugly!
I made pretty good progress today.
The 3D data is almost done, so all that’s left is to write the firmware and so on.
I hope it’ll be ready by tomorrow.
Today I built a smaller version of it.
I haven’t been able to spend much time on Hackclub lately because of preparations for the cultural festival, but it was nice to finally get back to it after so long.
I’ve finished the 3D model for now.
Since JLC3DP is charging an outrageous price, I think I’ll just print it myself using the club’s 3D printer.
I made the door and the back cover.
It looks really great.
I made the control panel section.
It’s starting to look like a microwave!
I drew up a circuit diagram today. I think the internal circuitry should be fine as is, but I’m worried that if the internal temperature gets too high and the case warps badly, that would be a problem, so I’m wondering if I should install a thermometer that can withstand UV exposure.
First devlog
