Build Phase #3

Completed the build phase first i unassembled everything and found out tht my soldering wasn’t the problem i checked with a multimeter but wht i did was greater js a soldering error. it was frikin pcb error. yeh so umm the oled thingie if u check its image on hackpad mission page u will see its pin order is down to up but wht i did in my pcb was tht the order was up to down so thts why it didnt work and reviewers didn’t even notice well its more my mistake than theirs anways so i thought maybe if i can desolder this i solder jumper wires from correct pin to its pad but naw i couldnt even desolder i tried using a desolder pump and a copper wick but it js didnt ;-; this is so dam insane!!!!! well anyways everything works except tht oled so yeh cool macropad successfully done!