• PCBWay reached out to sponsor my hackathon

• my hackathon was too close, so I said we could collaborate in the future

• i also asked if they could sponsor this project

• they said yes!

• i just need to update PCB + repo

• done!

• will email now

• ok i need to fix 3d print also

• right now, it’s not printable

• the handles and the rectangle on both sides is too big of an overhang

• so ill split the handles

• added holes

• made the handle

• used calipers IRL to gauge what dimensions i need

• noice!

• will adjust the dimensions

• ok im going to figure out how long ts will take to print

container: 4h45m, 212g
lid top: 49m14s, 33g
lid bottom: 1h33m, 64g
handles: 18m32s, 7g

• thats in total: 7h 25m, 316 g

• i think ill need to add 1kg filament because i’ll likely need to reprint stuff

• apparently 1 screw isn’t enough

• ok i need to add 2 screws

• nice!

• i added 3 screws cause why not

• i might not use all of them; we’ll see

• new cutout

• also larger