Devlog #7: hollowed out the belly and the nosecone — at first, I was super confused on how to hollow out round parts like those of lofts, so after a quick google search I discovered a tool, Shell. I’m so happy I found out about it because otherwise I would be fighting to extrude each part for hours lol. Like the fuselage, the belly and nosecone have 0.6mm of thickness (~0.0236 for the Americans!) — As for hollowing the nosecone, I struggled a bit because the inside and outside were unidimensional and floating, (I basically left a gap of 0.6mm between them) but I figured it was because I had made the windshield before hollowing the nosecone out, so I pushed the intersect booleans of the windshield and nosecone to the very end of the features list, which fixed it, as you can see in the ss! — next to do: figure a way to hollow out the wings and tail surfaces (I tried, but I had a couple problems due to the geometry)