I started arranging the stuff on the PCB, but today i had a lot to do other than techie stuff,
and went out with friends, then got my wallet stolen D: . Anyway after all that stress i wasn’t really feeling like
working on the project, but i didn’t wanna lose my streak so i did a little bit

i powered through arranging the key matrix properly, with all the diodes correctly aligned with the correct keys, and this was probably the most satisfying
part of the project - i think it looks neat

then i started arranging like the Headers and stuff

after that came the Audio section - and look at how tiny those chips are - im getting anxiety let alone looking at them, and am trying not to think about tryna
wire and then solder those tiny ass pins - look at that chip in comparison to a capacitor:

also i did the display part and used a 3D model i found of the component for measurements - i think its accurate enough

i also arranged a lil bit on the ESP and the like boot/power/key switches :

the rest i will do tomorrow - im really putting off placing the capacitors and resistors cause thats a pain in the ass -
id have to double check where every one goes cause the airwires go crazy cause of the Net labels i used and cause most of them are
decoupling capacitors, i have to check the schematic on how/where to place them, and im not looking forward to it.

Anyway thats all for today, see ya tmrw !