I’m starting to work on my SG90 robot arm! Honestly, coming into this project, I was a bit skeptical on how I would even start. But now that I did, I found that it wasn’t so hard! For this session, I technically worked for an hour, but I guess I forgot to take a time-lapse of it. I worked on getting all the materials, getting servo measurements, setting everything up, and finally modeling and printing a fit gauge to test if the measurements for the servo fit ok to continue. On to the base!  (Next session) In the next session, I’ll continue to get into things more, and probably start modeling the base. See you next time!!