I have to stop posting so often. But i did just finish the basic sketches of the robots parts. I’m now planning on making the knee bend because of the amount of prototyping I’m going to have to do and figure out what will be the best for this robot. I have looked at a few designs that i might be interested in. i will design these so i could buy motors in the future but that most likely will not be anytime soon. I would also love for the torso to rotate. But I’m not sure if that would be optimal. It sure would be cool though. I did post about this in a previous devlog. But i did realize that i had done my soldering job wrong. And even though i was able to connect to the chip it would not be able to write. So i re did the soldering