Hey everyone, so today im still doing the mouse. I took me so long to get the footprints and the library for the sensor to work. I spend alot of time downloading files trying different methods i found online asked ai to help me too. In the end i found how to do it by luck. But now i finally understand. So i copy pasted the sensor from a different project and the library stayed the same from the other project. All i had to do was go in its properties and there was a option to change its library to a local on so i did and that was it. After that i put everything in the pcb editor and started on placing everything. So now im facing a bunch of problems. First i cant connect everything cause the wires are intercepting one another and i dont ave enough space to put the scroll wheel. So my options are to put the wheel on the side of the mouse or make to pcbs and stack one onto the other or move the esp32 to the back meaning the wire will come from the back. For the wire i can stack 2 pcb again or do what gemini said and there is a way to make the wires go under each other. That i knew but there were a few components that only allowed to be on top but it said to make a small wire on top and then continue underneath. I might explained it a bid weirdly sorry im not the best in english. Anyway see u later