Today I continued my work on track widths, I looked back on the pcb made by the LattePanda team, which assisted me on how I should do it. I successfully(I think?) routed the tracks for the USB-C power I’m using. Nothing broke thankfully other than the fact that I had to replace some resistors. I learned that if a route is only carrying power like a screw terminal then it should be thicker usually, this doesn’t really apply to me too much because I modified the board to use USB-C for it’s only power source. I chose to use USB-C power over a screw terminal as it would be easier to find battery options that were more efficient and were made by reliable companies, which means it would be less likely to blow up, which is always good :). It surprised me that the USB-C track width could be almost the same as the standard size.