FINISHED THE BUILD OF THE STEPPING STONE FLYING WING

This is the flying wing i normally take out to fly and have fun, Ive had like 60% success rate with this model (without wingtip washout), Mostly because flying wings are hard to fly and i dont know how to fly

Good thing about flight computers is that they DO know how to fly so this would be a lil bit easier

Ive added 2.5 degrees of wingtip washout on this aircraft, also ran CFD sims on the entire wing profiile and saw that the stall characteristics are like a self stablizing feedback loop

I have done all the wiring and flying wing setup in the pixhawk, i just need to go fly to use the autotune mode to get the PID right for this model

One thing that is bad with this model is that the elevon throw when its going down is WAY less than compared to that when its going up so i hope that might not fk up the plane

Ive ran several indoor tests with the motor on and off, it does stall if not thrown properly but most of the time the launch is butter, lets hope its that way tmr too