CADding Case & PCB Finalization (Sec. 7 & 8)

Today I did a final check-over of the PCB, in order to get the correct sizing for my case, which I began and almost finished work on.

P.S. Fusion, i love u but u can be SO ANNOYING at times

Roadmap:

Completed Sections:

1: Getting Started with a Schematic
2: Beginning Wiring & Case, realizing it was all wrong, starting over
3: Creating 2.0 Schematic
4: Wiring 2.0 PCB
5: Troubleshooting 2.0 PCB
6: Adding Silkscreens
7: Final PCB Check
8: Design Case

Incomplete Sections:

9: Final Check-over of Everything
10: Create QMK Firmware
11: Submission of MyCroPad!

Section 7: Final PCB Check

Hours 6:30-6:45

• Just did a simple check-over of the PCB and finalized the sizing so that I could move on to the next section:

Section 8: Design Case

Hours 6:45-7:30

• Made the 3d model of most of the case. Now I just need to make some cutouts so that my awesome silkscreens are visible ;P